Pumacril^® Interior

Technical Caracteristics

Matte plastic paint with acrylic copolymers, fillers, pigments, and additives in dispersion.

Advantages and Uses

• Extraordinary whiteness and opacity.
• Good resistance to the substrate’s alkali.
• Good homogenisation of the product and easy to apply.

Suitable Substrates

NEW CONSTRUCTIONS:

• Remove any possible dust, grease, and any other contaminants.
• A FIJAMOR layer may be convenient diluted with 2-3 parts of water, to fix and equalise the absorption of the substrate. 
• Apply the paint according to the instructions given.

OLD CONSTRUCTIONS:

• Remove any mould contamination as well as any remaining paint or other construction materials.
• Level any irregularities with a suitable amount of paste. Let it dry and sand it.
• A FIJAMOR layer may be convenient diluted with 2-3 parts of water, to fix and equalise the absorption of the substrate. 
• Apply the paint according to the instructions given.

Application Procedure

• Shake until perfect homogenisation. 
• Apply a first diluted layer in 10-15% of water.
• You may dilute the second and subsequent coats with up to 5% of water.
• Apply with a brush, roller, or airless.
• Drying time to touch: 30  minutes.
• Cleaning of the tools will be conducted with solvents immediately after being used.

Recommendations

• Do not apply under 5ºC.
• Do not apply the product with relative humidity above the 85% nor on wet substrates.
• Storage: Inside its original closed packaging. In fresh and dry places, away from open air and direct sun light. Avoid extreme weather conditions (not lower to 5ºC nor above 35ºC).

Packaging and Storage

4 and 14 L tub.Shelf life: 1 year in sealed original packaging, sheltered from outside conditions and humidity

Technical data

Notas

The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.

GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.

In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.

The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.