Impermor
Colourless waterproofing liquid for the dampproofing of absorbent façades containing mineral origin materials.
Additional information
Composition
Mixture of solvents and organic products.
Features and applications
- Excellent waterproofing quality.
- High resistance to alkalis.
- Non-stick drying.
- Excellent penetration capacity.
- Completely colourless finish.
- May be applied on slightly wet surfaces.
Substrates
It can be applied on the following construction equipments:
- All types of concrete (including porous concrete) and mineral plaster coatings.
- Fibre cement sheets.
- Brick masonry and lime-sand blocks.
- Mineral-based natural and artificial stones.
- Priming coat for mineral origin and façade paints.
NOTE: Not recommended to waterproof gypsum plasterings.
Instructions for use
- Apply by means of a sprinkler or through an irrigation system.
- If possible, apply two or three times in a row, do not wait for the coat to dry between applications.
- The substrate can be slightly wet, i.e., though containing a certain amount of water, it should not show stains of humidity on the surface.
Cautions and recommendations
- Avoid prolonged contact of the product with the air (do not leave the container open).
- Keep the product at temperatures below 30º C and protected from direct sunlight.
- Do not dilute the product with any type of solvent, including water.
Packaging
1.5 and 20 l bags.
Shelf life: 9 months in sealed original packaging.
Technical data
| (Statistical data obtained under standard conditions) | |
| Aspect | Colourless liquid |
| Density | 1,05 gr / cm³ |
| Approximate Yield | See table |
Note
The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.
GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.
In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.
The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.
GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.
In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.
The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.