Pegoland^® Fix D1

Technical Caracteristics

Ready to use adhesive made with resins, and specific additives and agents, suitable for fixing any kind of ceramic cladding on vertical interior or exterior substrates.

Advantages and Uses

• Ready to use. No addition of water is necessary.
• Very flexible.
• Recommended for deformable substrates.
• Recommended to fix tiles on carton-gypsum boards.
• Application of polystyrene boards on mortar.
• Fixing by points of insulating panels.
• Tiling on well preserved surfaces made of gypsum.
• Tiling on well preserved painted surfaces.
• Temporary fixing of tiles on wood.
• Fixing tile over tile.
• Not suitable for floors.

Suitable Substrates

Substrates must be clean and free of dust, oil, paint, loose particles, etc
It is very important that the substrates are completely dry before the application
The substrate must be completely hardened.

Application Procedure

A) Mix Pegoland Fix to obtain a homogenous paste.
B) Spread in small areas using a max 4mm saw to level.
C) Press on the sides to level.
D) Wait 24 hours before grouting.Use the appropriate mortar from the MORCEMCOLOR range depending on the type of joint.

Recommendations

• Do not apply at temperatures below 5ºC nor above 35ºC.
• Do not apply with a saw notched trowel larger than 4mm.
• Do not apply in areas continuously exposed to humidity.
• Do not apply outdoors.
• Do not apply over metals.
• Do not apply under direct sunlight or on hot substrates.
• Do not set non absorbant tiles on non absorbant substrates.
• Maximum tile weight is 30Kg/m² and maximum size is 1600cm2 (as in 40x40)      when applying with Pegoland Fix Plus.
• Apply adhesive on the substrate and on the tile when tiles are equal or larger      than 900cm².

Packaging and Storage

2,6 and 25Kg containers.
Shelf life: 1 year in sealed original packaging, sheltered from weather conditions and humidity.

Technical data

(Statistical data obtained under standard conditions)

Legal Disclaimer

Notas

The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.

GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.

In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.

The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.