Malla Drypool
Double-twisted wire mesh, essential for reinforcement. Recommended for use in waterproofing systems for swimming pools, balconies, terraces, wet areas and coving fillets, providing the system with greater strength and stability, while preventing the appearance of cracks caused by temperature changes or movement.
Additional information
Technical Characteristics
Glass fibre strands covered by a resin that protects them from attack by the alkalis present in cement mortars.
Advantages and Uses
- Easy to apply.
- Highly resistant to alkali.
- Resistant to cracks.
- Great mesh stability.
Application Procedure
Apply using the “sandwich” method.
To do so:
- Apply a first layer of MorcemDry mortar onto the substrate.
- Position the mesh so that it is lightly embedded.
- Apply a second layer of MorcemDry mortar so that the mesh is fully embedded.
Recommendations
Managing this product does not require particular care, although it can cause some skin rush in more delicate skins.
In that case, clean the area with abundant cold water and soap.
Packaging and Storage
Rolls of 50 m long x 100 cm wide:
Store in a dry place, protected from direct sunlight and in an upright position.
Technical data
(Statistic results obtained under standard conditions)
|
Composition and thickness |
Glass fibre 0.55 mm ± 0.1 mm |
| Organic matter content (LOI) | 20 ± 4 % |
| Mesh light | 4.0 x 4.5 mm |
| Mesh weight | 147 gr/m2 |
| Tensile strength – Weave | ≥ 1800 N/5 cm |
| Tensile strength - Warp | ≥ 1900 N/5 cm |
| Tensile strength after 28 days in a 5% sodium hydroxide solution – Warp | ≥ 1000 N/5 cm |
| Tensile strength after 28 days in a 5% sodium hydroxide solution – Weave | ≥ 1000 N75 cm |
| Elongation- Warp | ≤ 5% |
| Elongation - Weave | ≤ 5% |
| Elongation after 28 days in a 5% sodium hydroxide solution – Warp | ≤ 3.5% |
| Elongation after 28 days in a 5% sodium hydroxide solution – Weave | ≤ 3.5% |
| Properties | High dimensional stability |
| Alkali resistance | |
| High tensile strength |
Notas
The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.
GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.
In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.
The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.