Paviland® Resina A10
Product based on the dispersal of pure acrylic resin which can be used as finishing in concrete paving and printed concrete, protecting them from external agents by sealing the pore.
Hardens through solvent evaporation and is especially advisable for concrete varnish, cut stone, etc, both in the interior and in the exterior, leaving a protective and decorative film with excellent properties.
Due to its small particle size, it has good anchorage to the paving and increases its cohesion.
Recommended as exterior printed paving protective and curing liquid.
Informations supplémentaires
Advantages and Uses
- Protection and sealing of exterior stony paving.
- Protection and curing of printed paving.
- Paving of industrial floor.
- Floor coating and repair.
- Exterior waterproofing plaster.
Application Procedure
- Apply immediately after hardening of surface to be treated, spreading the product directly by means of an atomiser and making sure to leave a uniform film, without excessive product accumulation and avoiding overly thick layers.
- Ordinarily, must be used pure, although performance can be increased diluting the product a maximum of 50% in water, depending on facing conditions, the specific use of the application and the effectiveness of finishing desired.
Recommendations
- Do not apply below 5ºC nor above 35ºC.
- Do not apply when there is a risk of frost, rain, strong wind or direct sunlight or relative humidity above 85%
- The product is not toxic, dangerous or inflammable under normal handling conditions. The use of special safety measures are not necessary, having to observe at all times those set forth under the Spanish Occupational Hazard Prevention Act.
Packaging and Storage
25 l. buckets.
Store in sealed original packaging, sheltered from weather conditions and humidity. Do not expose to temperatures below 5ºC nor above 35ºC.
Technical data
| (Statistical data obtained under standard conditions) | |
| Aspect | Milky liquid |
| Density (20ºC) | 1,04 ± 0,02 g/cm3 |
| Solid content | 38,0 ± 0,2 % |
| Dispersal degree | Very thin |
| Theoretical performance | 6-8 m2/l |