Malla Drypool
Morcem®Dry Mesh consists of double weave threads, essential for the reinforcing.
Recommended in the application of swimming pool waterproofing systems as DryPool. Gives the system great resistance and stability, and prevents the appearance of cracks caused by temperature differences or movements.
Additional information
Technical Caracteristics
Fiberglass threads covered by an special resin which protects them from alkaline attack of mortars.
Advantages and Uses
- Easy to apply.
- High alkalis resistance.
- Crack resistant.
- Great mesh stability.
- Test methods according to DIN 53 854 part2.
- Test methods according to ISO 13 934-1.
Application Procedure
- Apply a first layer of Traditerm mortar onto the substrate and place the mesh so that it is slightly embedded.
- Apply a second layer of MorcemDry mortar to completely cover the mesh.
Recommendations
Handling this product does not require special care, although, it can cause irritation to very sensitive skin. If this should happen, wash with sufficient cold water and soap.
Packaging and Storage
Technical data
| Composition | 100% fibeglass |
| Screen size | 2.4 x 2.4 mm |
| Mesh weigh | 60 g/m2 |
| Tensile strength - Weave | Aprox 650 N/5 cm |
| Tensile strength - Warp | 850 N/5 cm |
| Extension to the breakage - Weave | 3.75% ± 0.27 |
| Breakage resistance - Warp | 3.17% ± 0.26 |
| Chemical resistance | Good resistance to alkalis |
Notas
The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.
PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.
It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.
In the event of a claim, the original packaging must be provided to ensure proper product traceability.
Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.