Morcem^® Texture Resina

Advantages and Uses

• Protection of coatings.
• Good adhesion and sealing capacity.
• It increases the resistance to impact and abrasion providing a finish with great hardness and good flexibility.
• It has a very good waterproofing capacity preventing the emergence of efflorescence.

Application Procedure

• Apply immediately after the surface to be treated has hardened. Spread the product directly by using a spray, endeavoring to leave a uniform film, without an excessive accumulation of the product, and avoiding leaving layers which are too thick.
• It should usually be used pure, although the yield can be increased by diluting the product up to a maximum of 30% with Xylene, naphtha or aromatic hydrocarbons, depending on the condition of the substrate, the specific purpose of the application and the effectiveness of the finish which is wanted.

Recommendations

• Do not apply at temperatures below 5°C or above 35°C.
• Do not apply if there is a risk of frost, rain, strong wind, direct sunlight or if the relative humidity is greater than 85%.
• The product is harmful and flammable under normal application conditions. It is necessary to use the special measures contained in the safety datasheet and to comply, at all times, with the stipulations of the Law on Prevention of Occupational Risks.

Packaging and Storage

25 liter containers.Store in its sealed original packaging, sheltered from weather conditions and humidity, and avoid exposing it to temperatures below 5°C or above 35°C.

Technical data

(Statistical data obtained under standard conditions)

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.