Traditerm^® NC

Technical Caracteristics

Made from hydraulic conglomerates, selected aggregates and additives.

Advantages and Uses

• Especially made for the bonding of boards on non conventional substrates.
• Manual application
• Excellent adherence.
   

Suitable Substrates

• Mortar renderings or other substrates of a similar mineral nature with a certain degree of porosity.
• OBS  wood plates
• Ceramic tiles or very well adhered to tiles.
• Paint in good state 
• Waterproof bricks.
• Substrates must be resistant, stable, healthy and clean, free of dust, remains of release agents and organic products.
• Take into account  the resistance compatibility of the substrate with  the mortar used.
• In case of hot, wind or very absorbent substrates, wet the substrate and wait until the complete film of water disappears.
• Do not apply on top of plaster.
   

Application Procedure

• Mix the product with water until getting a homogeneous paste: 20% approximately.
• Fix the insulating plates to the substrate, using TRADITERM NC mortar.

DENTED TROWEL METHOD

• Spread and comb the TRADITERM adhesive on the insulating panel, using the notched trowel. This way a homogeneous distribution of the adhesive is obtained over the plaque.
• Remove the TRADITERM bit close to the plaque (2cm approximately).
• This is done when the flatness of the substrate is <5 mm using a 2 m ruler to measure it.

Recommendations

• Substrates (bricks, plasters, concrete, OSB, paints...) must be clean (free of dust, traces of paint in bad condition, greases, release agents, etc.)
• The person in charge must make sure that, in the event of applying the product on top of any other paint, this pain is in good state.
• Substrates with greater than 1 cm, incline, should be previously regularized.
• Insulating panels should never cover the building's expansion joints. As a solution, please use the expansion profile.
• Protect the upper part of the façade to avoid possible water filtration.
• The adhesive does not exempt the placement of anchor plugs.
• Do not apply the product under extreme weather conditions.
• Do not apply it under the rick of freeze, rains, heavy winds or direct sun light.
• Do not apply in areas where there might be stagnant water. 
• Under extreme weather conditions (heavy wind or high temperatures) the drying process may be faster than usual.

Packaging and Storage

5 kg laminated paper sacks.
1 year storage in its original packaging, away from extreme weather conditions and humidity.
 

Technical data

(Statistic results obtained in standard conditions)

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.