Traditerm^® Perfil Coronación

Technical Caracteristics

aluminium profile.

Advantages and Uses

• Easy to apply.
• Protects and reinforces the sides of Traditerm Systems (SATE/ETIC).
• It does not get rusted.
• Range of thickness to choose from according to the insulation panel used.

Application Procedure

For its correct installation fix the profile to the substrate using screws for exterior areas, taking into account that:

• The profile should be placed before applying the last superior insulating panels.
• The screws used in order to fix the coronation profile to the substrate should be placed with a minimum separation of 30 cm between them. The first screw should be placed with an inferior distance to 5 cm from the profile's border.
• Between a  coronation profile and another,, leave 2 to 3 mm distance that should also be sealed using Pumalastic MS.

Recommendations

• The superior area where the profile meets the substrate where it has been fixed to, should always be protected (by the eaves of the façade itself, by other profile...)
• Choose the correct closing profile according to the thickness of the insulating panel.
• Seal with Plumalastic MS the areas where the coronation profile and the finish layer of the system meets, the encounters between the side closing profiles and the starting profiles and the encounters among other elements in the façade (substrate...)

Packaging and Storage

10 units box->25 lineal meters.
The profiles should be stocked up in horizontal position.

Technical data

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.