Traditerm® Perfil Goterón PVC con Malla
Profile for reinforcing and forming guttering in the TRADITERM® thermal insulation system. Its morphology allows a correct evacuation of rainwater on the facade preventing the deterioration of carpentry and the Thermal Insulation System itself from the outside (SATE) in these meetings.
Additional information
Technical Caracteristics
PVC profile with anti alkali fibreglass mesh.
Advantages and Uses
- Leave a 2-3 mm separation distance between the profiles.
- Once the profile has been positioned, leave it to dry for a minimum of 24 hours.
Application Procedure
Apply a coat of TRADITERM® mortar on the two surfaces forming the corner, in a layer that incorporates both the profile and the mesh. Next position the profile over the mortar and press gently. With the help of a level, correctly position the profile. Cover the upper face of mesh with TRADITERM® mortar.
Recommendations
- Leave a 2 - 3 mm separation distance between the profiles.
- Once the profile has been positioned, leave it to dry for at least 24 hours.
Packaging and Storage
Boxes of 10 units (25 linear metres). The profiles must be stored horizontally.
Technical data
(Results obtained in laboratory under standard conditions)
| Composition | PVC and Fibreglass with anti-alkali treatment. |
| Approx | Weight. 0.20 kg/m |
| Profile length | 2.5 m |
| Dimensions: |
Notas
The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.
PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.
It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.
In the event of a claim, the original packaging must be provided to ensure proper product traceability.
Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.