Traditerm^® Taco de Anclaje

Technical Caracteristics

The anchor is formed of two elements:

• Nail: fiberglass reinforced polyamide
• Sheath: polyethylene

Advantages and Uses

• Easy to apply.
• Ensures perfect fastening of the panels to the substrate.
• Resistant to oxidation.
• Range of sizes, depending on the thickness of the panel.
• Anchor with European certification.

Application Procedure

• After 24 hours from the fixing of the insulation boards to the facade with TRADITERM adhesive, using a drill, make a hole in the support, passing through the insulating panel. The depth of the hole in the bracket must be 60 mm.
• Place the TRADITERM® TACO DE ANCLAJE in the hole made.
• With the help of a mallet, hit the anchor so that it penetrates until it cuts the surface by 1-2 mm of the insulation board.
• Subsequently, the recess produced on the surface of the insulating panel is regularized with the mortar TRADITERM®.

Recommendations

• The plug must be inserted at least 50 mm into the holder.
• The plug must cut the insulation panel by 1-2 mm. If the plug is not inserted into the insulation, the insulation will marked on the final finish.
• Check that the blocks are securely fixed.
• Hammering into studs with nails already installed is not recommended as it may cause damage to the plate.
• The hole in solid materials should be cleaned of any debris prior to installation.

• Depending on the thickness of the insulation panel, the following thicknesses of TRADITERM® TACO DE ANCLAJE are recommended:

Packaging and Storage

Boxes with the following format (depending on the length of the anchor):

Keep the anchors protected from the weather and solar radiation.

Technical data

(Data obtained in a laboratory under standard conditions)

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.