Traditerm^® Taco de Anclaje STR H

Technical Caracteristics

Plastic anchor with zinc screw.

Advantages and Uses

• Fast and easy to apply.
• It ensures a great quality fixation of the insulating panels on wooden substrates.
• Possibility of hidden anchorage in the system.
• Fixation of insulating panels in exterior thermal insulation Traditerm systems.
• Permanent contact pressure.
• Range of sizes, according to the insulating panel thickness used.

Application Procedure

24 hours after the fixation of the insulation panels  to the substrate, with the Traditerm NC adhesive, make a hole in the substrate with a drill, crossing the insulating plaque.

There are two ways to place the Traditerm Taco de Anclaje STR H:

• Método Interior Aislante (Interior Insulating method)

Place the Traditerm taco de anclaje STR H on the hole done and screw it towards the inside with the help of “Traditerm Kit Corona STR”.

Once the anchor has been introduced in the insulator, place the corresponding "Traditerm Tapa Aislante" according to the insulating type.

• Método Superficial. (Superficial method)

On top of the hole done, place the anchor and screw it until it reaches a point where it cuts by 1-2mm the surface of  the insulating panel.
Place “Traditerm Tapón STR” and level the surface with Traditerm®.mortar.

Recommendations

• The anchor should be inserted at least 30-40 mm  intothe substrate.
• The anchor should cut the insulating panel by 1 mm in case of using the Superficial method. If the anchor is not inserted in the insulation panel , it will remain seen in the final finish.
• Make sure the anchor are well fixed.
• According to the insulating panel, we suggest the following thickness from Traditerm Taco de Anclaje STR H:

Packaging and Storage

Anchor is presented in 100 units boxes.
Keep away from open air and sun radiation.

Technical data

(Results obtained under standard conditions in laboratory)

Loads of use advised

Use loads suggested are calculated with a security factor of 3. They may differe according to the purpose. 

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.