Traditerm® Tornillo SF 300
Screw for mechanically fastening TRADITERM® 300 Mounting. This steel screw ensures that the rigid polyurethane element is fixed at four points, by anchoring this piece to the support, provided that the latter has suitable resistance conditions on its surface for its correct anchorage.
Additional information
Technical Caracteristics
Zinc-plated steel screw.
Advantages and Uses
For mechanically fastening TRADITERM® 300 Mounting.
Application Procedure
Drill the holes where the SF TRADITERM® 300 screws will be used for mechanical fastening element.
Recommendations
The SF TRADITERM® 300 Screws must always go through facings and be joined to the actual facade wall.Check the substrate is resistant enough to support the element to be fastened.Always use all 4 SF TRADITERM® 300 Screws for fastening TRADITERM® 300 Mounting.Respect the maximum load limit to support TRADITERM® 300 Mounting.
Technical data
| Zinc-plated steel screw. | |
| Length | 100 mm |
| Ø Drill hole | 10 mm |
| Minimum drill depth | 80 mm |
| Minimum embedded depth of screw | 70 mm |
| Drive | Hexagonal SW13 and Torx T40 |
Notas
The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.
PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.
It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.
In the event of a claim, the original packaging must be provided to ensure proper product traceability.
Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.