Malla Drypool
Double-twisted wire mesh, essential for reinforcement. Recommended for use in waterproofing systems for swimming pools, balconies, terraces, wet areas and coving fillets, providing the system with greater strength and stability, while preventing the appearance of cracks caused by temperature changes or movement.
Additional information
Technical Characteristics
Glass fibre strands covered by a resin that protects them from attack by the alkalis present in cement mortars.
Advantages and Uses
- Easy to apply.
- Highly resistant to alkali.
- Resistant to cracks.
- Great mesh stability.
Application Procedure
Apply using the “sandwich” method.
To do so:
- Apply a first layer of MorcemDry mortar onto the substrate.
- Position the mesh so that it is lightly embedded.
- Apply a second layer of MorcemDry mortar so that the mesh is fully embedded.
Recommendations
Managing this product does not require particular care, although it can cause some skin rush in more delicate skins.
In that case, clean the area with abundant cold water and soap.
Packaging and Storage
Rolls of 50 m long x 100 cm wide:
Store in a dry place, protected from direct sunlight and in an upright position.
Technical data
(Statistic results obtained under standard conditions)
|
Composition and thickness |
Glass fibre 0.55 mm ± 0.1 mm |
| Organic matter content (LOI) | 20 ± 4 % |
| Mesh light | 4.0 x 4.5 mm |
| Mesh weight | 147 gr/m2 |
| Tensile strength – Weave | ≥ 1800 N/5 cm |
| Tensile strength - Warp | ≥ 1900 N/5 cm |
| Tensile strength after 28 days in a 5% sodium hydroxide solution – Warp | ≥ 1000 N/5 cm |
| Tensile strength after 28 days in a 5% sodium hydroxide solution – Weave | ≥ 1000 N75 cm |
| Elongation- Warp | ≤ 5% |
| Elongation - Weave | ≤ 5% |
| Elongation after 28 days in a 5% sodium hydroxide solution – Warp | ≤ 3.5% |
| Elongation after 28 days in a 5% sodium hydroxide solution – Weave | ≤ 3.5% |
| Properties | High dimensional stability |
| Alkali resistance | |
| High tensile strength |
Notas
The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.
PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.
It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.
In the event of a claim, the original packaging must be provided to ensure proper product traceability.
Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.