Morcem^® Rápido R1

Technical Caracteristics

High resistance cements, selected silica aggregates and specific additives.

Advantages and Uses

• Repairing mortar R1 according to EN-1504-3.    
• Anchoring of window and door frames.
• Small concrete repairs.
• Fixing of registers or closures for wastewater.
• Temperature influences setting time, which is shorter in hot weather and longer in cold weather. 
• Fast setting.

Suitable Substrates

• Substrates must be clean of dust, oil, extranged product.
• All ordinary masonry substrates are suitable: brick, concrete block and cement mortar.

Application Procedure

• Add water (3 to 3,5 liters per bag) , add the powder and mix (best if mechanically mixed) until ahomogenous and creamy mixture is obtained
• Wet the substrate throughly and then apply the product to desired thickness
• Curing starts a few minutes after application. From this moments and until total hardening, the product can be modeled easily with any suitable metal tool.

Recommendations

• Do not apply below 5ºC nor above 30ºC.
• Do not apply when there is a risk of frost.
• Keep wet and protect from weather in case of hot or windy conditions or if under direct sunlight.
• Mix only the amount of product to be used during working period.
• Do not re-mix nor add water to a mortar that has already started to cure. It cannot be re-used, it must be disposed of.
• Do not apply on gypsum or derivatives.

Packaging and Storage

20 kg and 5 kg plastic-coated paper bags
Shelf life: 1 year in sealed original packaging, sheltered from weather conditions and humidity.

Technical data

(Statistical data obtained under standard conditions)

CE Mark

GRUPO PUMA ESPAÑA Avda. Agrupación Córdoba 17, 14014 Córdoba 24 Nº: 210022
EN-1504-3 MORCEM RÁPIDO CC mortar fot non-structural repairs of concrete, minor concrete reparis and anchorages of window and door frames which require a mortar thet sets and hardens quickly (madre with hydraulic cement).
Resistence to compression	R1 Class
Chloride content	≤  0.05%
Adherence	≥ 0.8 MPa
Thermal compatibility part 4	No fissures
Capillary absorption	≤ 0.5 kg m-2 h-0.5
Fire reaction	A1

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.