Morcem^® Ultra Rápido

Technical Caracteristics

Hydraulic binders and additives.

Advantages and Uses

• Application as pure paste or mixture.
• Adjust setting by addition of retarder.

As paste:

• Securing bolts and wedges.
• Sealing water leaks.
• Setting regulator in mortars.

As mortar:

• Minor repairs of concrete and floors.
• Securing and positioning of manholes, pipes, lintels, junction boxes, etc.
• Quick masonry, grouting and restoration.
• Presentation, joints and edges.

Suitable Substrates

• Substrates should be free of dust, grease, paint and alien products.
• All usual masonry substrates are acceptable: ceramic bricks, concrete blocks, concrete and cement mortars (min. M 7.5).

Application Procedure

• Wet the substrate thoroughly and, when the excess water has been absorbed, apply the product to the desired thickness.

As paste:

• Put water into the container (6-7 liters per bag), pour in the powder and mix (mechanical mixing is recommended) until getting a creamy, homogenous paste of the right consistency.

As mortar:

• Put the aggregate and the cement in a 1:1 ratio and, if necessary, the retarder additive into the container, mix dry, add water (6.5 - 7.5 liters per bag) and mix mechanically until getting a creamy, homogenous paste of the right consistency.

• A few minutes after application the setting begins and, from then until the hardness becomes too great, the product can easily be sculpted, with any suitable metal instrument, to remove protrusions, smooth burrs, etc.
• Apply all the paste before setting begins.

Recommendations

• Do not apply at temperatures below 5⁰C or above 30⁰C.
• Do not apply if there is a risk of frost.
• Use clean sand for its use as mortar.
• Avoid using too much mixing water.
• If there is strong wind or direct sunlight, protect the product and wet it again to avoid it drying too quickly.
• Only mix the amount that you can use in the work time available.
• Do not remix or add water to a mortar that has begun to set. It cannot be used and should be disposed of.
• Do not apply on plaster or plaster products.
• The temperature affects the time when setting begins, in hot weather it makes it shorter and in cold weather it makes it longer.

Packaging and Storage

20 Kg plastic-coated bags and 5 Kg polyethylene bags.
Shelf life: 12 months in its sealed original packaging, sheltered from weather conditions and humidity.

Technical data

(Statistical data obtained under standard conditions)

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.