Morcemrest^® Obturador

Technical Caracteristics

Product based on hydraulic bonding agents and organic and inorganic additives.

Advantages and Uses

• Sealant for water filtration in concrete and cement-based substrates.
• For urgent repairs when wet.
• For anchorage and sealing that require fast curing.
• It waterproofs the surface where applied.
• Almost instant setting.
• It sets even under water.

Suitable Substrates

• Concrete, smooth concrete premade blocks and plaster work rich in cement.
• Substrates must be resistant, stable, sound and clean, free of dust, demolding agents, organic products, etc.
• In case of hot or windy weather conditions or when applying over absorbent substrates, it is advisable to wet the substrate and wait till the thin layer of water disappears.

Application Procedure

• Prepare the surface by removing a few centimeters of the concrete in bad condition.
• Clean by intense brushing.
• Mix only the material to be used within 20 seconds. If you are stopping a water leak then use just enough material to be worked with one hand (use gloves):
• Remove the leftover material and even to the original substrate.         

Recommendations

• Do not apply below 5ºC nor above 30ºC.
• Do not try to remix with water any hardened product.
• Wear gloves when using this product.
• Once open, it is recommended that you use the material immediately or else seal the bag at once.
• At high temperatures, setting will occur instantly.

Packaging and Storage

5 kg polyethylene bags.
Shelf life: 6 months in sealed original packaging, sheltered from weather conditions and humidity.

Notas

The information and instructions in this datasheet are based on our current tests and technical knowledge. They are intended as general guidance and do not constitute a binding commitment by PIDILITEPUMA MEA CHEMICALS LLC. It is the sole responsibility of the user to verify, prior to use, that the product is suitable for the intended application and to ensure that it is applied correctly and in accordance with applicable regulations and good industry practice.

PIDILITEPUMA MEA CHEMICALS LLC cannot control how its products are applied on site throughout the entire project and therefore cannot accept responsibility for their application by contractors or other parties involved in the execution of the work. Support visits to the jobsite by our technical staff do not change that. Our responsibility is limited exclusively to defects that can be directly attributed to the supplied products, whether used individually or as part of a system, caused by manufacturing defects.

It is the responsibility of the project designer, site manager, contractor, or other relevant professionals to ensure that the selected products are appropriate for the specific project, taking into account their properties, the substrate, site conditions, and any existing issues.

In the event of a claim, the original packaging must be provided to ensure proper product traceability.

Any performance values stated for PIDILITEPUMA MEA CHEMICALS LLC products or construction solutions, whether in UNE standards or other applicable standards, are based solely on the specific test conditions defined in those standards (such as substrate type, temperature, and humidity). These values may not apply to situations where products are tested or used under different conditions.