Paviland® Industrial EF

Powdered product which, when applied on fresh concrete forms a large, uniform surface layer with very high resistance to abrasion, especially designed for high performance industrial flooring.


Download technical data sheet

Additional information


Product made with high strength Portland cement, pigments, additives and specially selected aggregates with high resistance to abrasion.

Features and applications

  • Industrial warehouse floors.
  • High mechanical strength.
  • High resistance to abrasion.
  • Variety of colors.
  • Unaffected by the weather.
  • Waterproof and impermeable to grease and oil due to its structure and method of application.

Instructions for use

  • Prepare the substrate with suitable meshes to reinforce the concrete.
  • Protect the areas which have to be kept clean.
  • Pour the concrete and smooth with a trowel.
  • Get the levels to level the surface.
  • The leveling of the concrete can be done with vibrating trowels or manually.
  • Pass a power float or helicopter over it to open the concrete.
  • Sprinkle the surface layer which forms PAVILAND INDUSTRIAL EF on to the fresh concrete.
  • Pass the helicopter over it again, homogenizing the surface layer, until it is completely smooth and hardened.
  • The application of protection and/or curing resins of PAVILAND RESINA range of products is recommended to prevent the superficial layer from drying too quickly thus avoiding the dehydratation of the mortar, especially in conditions of high temperature and/or strong wind.
  • Cut and wash the expansion joints.

Cautions and recommendations

  • Do not apply at temperatures below 5⁰C or above 30⁰C.
  • Do not apply if there is a risk of frost, rain, strong wind or direct sunlight.


25 kg laminated paper sacks.
Shelf life: 12 months in its sealed, original packaging, sheltered from weather conditions and humidity.

Technical data

(Statistical data obtained under standard conditions)

Appearance COLORED powder
Apparent density of the powder 1.9 ± 0.2 g/cm³
Approximate yield (*) 4-5 kg/m² for an average thickness of 0.5 cm
Resistence to Flexion (UNE-EN 13892-2) > 7 n/mm²
Resistence to Compression  (UNE-EN 13892-2) > 40 n/mm²
Abrasion  < 450 mm³

(*) The performance can be increased depending on the shade chosen and the colour of the concrete used.
For the white colour, consult the technical department.


The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.

GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process.

In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.

The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.