Traditerm^® Perfil Arranque PVC Pared

Technical Caracteristics

Resistant PVC.    

Advantages and Uses

• It lays the building’s foundation for the starting of the system and it ensures it’s levelness.
• Up to 300 mm thicknesses.
• It removes thermal bridges,
• It is easy and quick to install.
• It helps to create perfect aesthetic details
   

Application Procedure

• Place the Perfil de arranque PVC pared on the wall and level it with a bubble level.
• Mark the points to drill the holes in the dowels without hammering.
• Distance among the dowels should be between 30-50 cm.
• Insert the dowel through the deep and clean pre-drilled hole in the profile.
• Secure the profile.
• Apply the Traditerm / WalAce mortar on the insulation panel and glue it to the substrate placing it on top of the Perfil de arranque PVC pared.
• Apply a Traditerm /WalAce mortar strip of at least 15 mm thick on the front of the panel from the inferior edge.
• Place the extension piece (Traditerm Perfil de arranque PVC extensión) in the front part of the Perfil de arranque PVC cierre oculto, if necessary, and lodge between the insulation panel and the Perfil de arranque PVC pared.
• Use the pins of connection to link the starter track profile with hidden closure. Remove any possible excess of Traditerm /WalAce mortar.
   

Recommendations

• Drill without smacking to avoid breaking the hollow bricks in the partition walls 
• Clean the holes made on the substrate with air to remove dust.
• To avoid deformations in the profiles due to irregular walls, use the spacers for assembly.
• Leave a separation distance of 2 to 3 mm between profiles.
• Put a screw every 30-50 cm distance to attach.
• There must always be an attachment, at a distance of less than 5 cm from the end of the TRADITERM® Perfil de Arranque.
• Select the starter track according to the insulation panel thickness.
• The meeting between the substrate and the TRADITERM® Perfil de Arranque must be sealed with PUMALASTIC MS.

NOTE: When the product covered by this Technical Data Sheet is used as part of a GRUPO PUMA system or construction solution, as it is officially defined as a component thereof, the specific instructions and recommendations contained in the corresponding technical documentation must be followed in all cases, specifically, but not limited to, the Manual relating to the system or construction solution in question.

Packaging and Storage

Boxes of 15 units at 30 linear meters.
Profiles must be stored horizontally.
 

Technical data

(Results obtained in laboratory under standard conditions)

Start Profile Placement

Legal Disclaimer

The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability. GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process. In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question. The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation.